Click here for Charlie and Grace from Ashton-Drake instructions

After you have installed one of these neck pieces you shouldn't need any additional help.

The instructions for installing the neck piece in the Special Edition doll is different than installing the neck piece in the smaller Berenguers.

The small neck piece will fit in most of the smaller all vinyl Berenguer Dolls along with the CitiToy doll.

The large neck piece, SEN fits the Special Edition European all vinyl Berenguer Doll

I like to put a little P.K. Plastic Cleaner or a light mixture of dish washing detergent around the entrance of the neck. (see picture)

(The above P.K. Plastic Cleaner belongs in the studio of all reborn artists.)

On the Special Edition I suggest putting the neck piece into the finished head FIRST, that is before putting the body on the neck.

Each Special Edition head is just a bit different in size so you might have to work a bit harder to put the neck piece in. Don't be alarmed it will go in.

If when you get this far into the neck you are having problems slightly moisten the black rubber seal. Careful, don't over do it, you don't want a wet Baby!

When the neck piece looks like this it is correctly in place. You can now install the head on the new cloth body.

When installing the smaller neck piece it is suggested that you first install the body onto the neck piece.

Cut away the access nylon tie.

Again, slightly moisten the inside of the neck.

Place the head onto the neck piece .

When you reach the black rubber you can slightly tilt the head and push over the black rubber.

Rotate head slightly and finish the downward motion. When the head covers all of the black rubber it is in place.

To order any of the above items simply add them to the PayPal cart.